Table of Contents
Advertisement
Adjusting the Speakers
BAL: Turn this control behind the FADE knob to move
the sound between the right and left speakers. The middle
position balances the sound between the speakers.
FADE: Turn this knob to move the sound between the
front and rear speakers. The middle position balances
the sound between the speakers.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30 to 45 minutes long on each side. Tapes longer than
that are so thin they may not work well in this player.
The longer side with the tape visible should face to the
right. If you hear nothing or hear just a garbled sound, it
may not be in squarely. Press EJECT to remove the tape
and start over.
Once the tape is playing, use the knobs for VOL, FADE,
TREB, BASS and BAL just as you do for the radio. The
lighted arrows show which side of the tape is playing.
REW (1): Press this button to reverse the tape rapidly.
Press REW or RCLPROG to return to plaving speed. If
you press RCLRROG, the tape will also c nqe sides.
R*M
(2): Press this button to hear the radio when you
are fast forwarding or reversing a cassette tape. You can
use the
TUNE, SEEK
and PRESET SCAN buttons
while in the radio monitor mode. The six preset buttons
cannot be used while in this mode.
FF (3):
Press this button to advance rapidly to another
part of the tape. Press FF, RCLPROG or EJECT to
return to playing speed.
PREV
(4): Press this button to go back to the beginning
of the last selection. Press PREV again or press
RCLPROG or EJECT to cancel this function.
00
(5): Press this button to reduce background noise
from tapes encoded with Dolby NR.
Dolby@ Noise Reduction is manufactured under a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
NEXT
(6): Press this button to go forward to the
beginning of the next selection. Press the button again or
press RCLPROG or EJECT to cancel this function.
For NEXT to work properly, your tape must have at
least three or four seconds of silence between each
selection. If you press RCLmROG, the tape will also
change sides.
3-10
Advertisement
Table of Contents
