Motorola MC55 Integrator Manual page 96

7 - 6 MC55 Integrator Guide
Troubleshooting the MC55 (Continued)
Table 7-1
Problem
A message appears
stating that the MC55
memory is full.
The Charging/Battery
Status LED flashes
with the Power button
is pressed and the
MC55 does not turn
on.
Camera application
does not launch.
The MC55 does not
decode with reading
bar code.
Cannot connect to
service provider.
Cause
Too many files Delete unused memos and records. If necessary, save these
stored on the MC55. records on the host computer (or use an SD card for additional
memory).
Too many Remove user-installed applications on the MC55 to recover
applications installed memory. Select Start > Settings > System tab and tap the
on the MC55. Remove Programs icon. Select the unused program and tap
Remove.
The MC55's battery Recharge the battery.
is low.
DataWedge Stop DataWedge application. Tap Start > Settings > System >
application running. Task Manager. Select DataWedge application and tap End
Task.
Scanning application Load a scanning application on the MC55. See the system
is not loaded. administrator.
Unreadable bar Ensure the symbol is not defaced.
code.
Distance between Place the MC55 within proper scanning range.
exit window and bar
code is incorrect.
MC55 is not Program the MC55 to accept the type of bar code being scanned.
programmed for the Refer to the EMDK or Control Panel application.
bar code.
MC55 is not If the MC55 does not beep on a good decode, set the application
programmed to to generate a beep on good decode.
generate a beep.
Battery is low. If the scanner stops emitting a laser beam upon a trigger press,
check the battery level. When the battery is low, the scanner
shuts off before the MC55 low battery condition notification.
Note: If the scanner is still not reading symbols, contact the
distributor or Motorola.
SIM not installed Re-install SIM card.
properly.
Solution