Displaying System Information; Restoring Factory Default Settings In Setup Utility; Exiting Setup Utility; Using Hp Pc Hardware Diagnostics (Uefi) - HP Computer User Manual

Displaying system information

1. Start Setup Utility.
2. Select the Main menu. System information such as the system time and date, and identification
information about the computer is displayed.
3. To exit Setup Utility without changing any settings, use the arrow keys to select Exit > Exit
Discarding Changes, and then press enter.

Restoring factory default settings in Setup Utility

1. Start Setup Utility.
2. Use the arrow keys to select Exit > Load Setup Defaults, and then press enter.
3. When the Setup Confirmation is displayed, press enter.
4. To save your change and exit Setup Utility, use the arrow keys to select Exit > Exit Saving
Changes, and then press enter.
The Setup Utility factory settings take effect when the computer restarts.
NOTE: Your password, security, and language settings are not changed when you restore the
factory settings.

Exiting Setup Utility

To exit Setup Utility and save your changes from the current session:
●
If the Setup Utility menus are not visible, press
arrow keys to select Exit > Exit Saving Changes, and then press enter.
To exit Setup Utility without saving your changes from the current session:
●
If the Setup Utility menus are not visible, press
arrow keys to select Exit > Exit Discarding Changes, and then press enter.

Using HP PC Hardware Diagnostics (UEFI)

HP PC Hardware Diagnostics is a Unified Extensible Firmware Interface (UEFI) that allows you to run
diagnostic tests to determine whether the computer hardware is functioning properly. The tool runs
outside the operating system so that it can isolate hardware failures from issues that are caused by
the operating system or other software components.
To start HP PC Hardware Diagnostics UEFI:
1. Turn on or restart the computer, quickly press esc, and then press f2.
The BIOS searches three places for the diagnostic tools, in the following order:
a. Connected USB drive
NOTE:
Downloading HP PC Hardware Diagnostics (UEFI) to a USB device on page
b. BIOS
2. When the diagnostic tool opens, use the keyboard arrow keys to select the type of diagnostic
test you want to run, and then follow the on-screen instructions.
To download the HP PC Hardware Diagnostics (UEFI) tool to a USB drive, see
esc to return to the menu display. Then use the
esc to return to the menu display. Then use the
Using HP PC Hardware Diagnostics (UEFI)
42.
41