Dubbing Images Stored In The Built-In Memory To A Tape - JVC GR DVL 200 Instructions Manual

46
EN
Power Switch
Recording
Start/Stop Button
Rewind Button (2)
VIDEO/DSC Switch (Open the
LCD monitor to access this switch.)
T O C
P US H
Lock Button
Fast-Forward
Button (3)
Display
OP Y T O T A P E
S TA R T / S T O P
R E C
4 4 4
Dubbing Images Stored In The Built-in
Memory To A Tape
Images can be dubbed from the camcorder's built-in
memory to a tape.
1
Load a cassette (
2
To locate the point where you wish to dub a still
image, play back the tape. Stop playback at the
desired point.
3
Set the VIDEO/DSC Switch to "
2
Power Switch to "
Lock Button located on the switch.
4
To select a still image to be dubbed, perform Index
3
Playback ( pg. 35) or press 2 or 3 to select the
image you wish.
5
To engage Dub-Standby, press the Recording Start/
Stop Button. The message "TO COPY TO TAPE PUSH
START/STOP" appears.
6
While the message is being displayed, press the
Recording Start/Stop Button. The selected still image
is recorded on the tape for approx. 5 seconds.
•The indicator disappears when dubbing is
complete.
NOTE:
If the Recording Start/Stop Button is pressed in step 5 when
the tape's erase protection tab is set to "SAVE", the
message "COPYING FAILED" is displayed.
DUBBING
pg. 10).
", then set the
" while pressing down the
(cont.)