Voice Recognition - Cadillac STS 2008 Customer Convenience/Personalization Manual

76880_08a_STS_GTK:STS 2007 A
The remote start system will not
operate if the hood or a door is
open.
Starting the Vehicle
1. Aim the transmitter at the vehicle.
2. Press and release the
button on the transmitter.
3. Immediately press and hold the
(Remote Start) button for about
four seconds.
4. When the parking lamps flash,
release the button. The engine will
start and the parking lamps will
remain on. The engine will
continue to run for 10 minutes.
5. Repeat these steps for a 10-minute
time extension.
When you enter the vehicle after a
remote start, press the Start button
to transition to normal vehicle
operation before driving.
Note: If the Check Engine light is illuminated
on the instrument panel cluster, Adaptive
Remote Start cannot be used. See your
dealer for the proper repairs.
Canceling a Remote Start
If you wish to turn off the engine
instead of driving after a remote
S
5/11/07 4:15 PM Page 10
start, perform one of the following
functions:
• Press and hold the Remote Start
button until the parking lamps
turn off.
• Press and release the Hazard
(Lock)
Warning Flashers button inside the
vehicle. Press the button again to
turn off the flashers.
• Press the Off/Accessory button on
and then off.
• The engine will automatically stop
when time expires.

VOICE RECOGNITION

(if equipped)
This feature allows for hands-free
operation of your navigation and
T S
audio system. It can be used when
the ignition is in the On or Accessory
position. The system is programmed
for the English language only.
Using Voice Recognition
1. Press the
steering wheel until a beep
sounds. Voice recognition is active
when the microphone symbol is
displayed on the navigation
screen.
2. Clearly speak one of the available
commands listed in your
Navigation manual. The system
will repeat and implement the
command.
If the system does not recognize a
spoken command, try again. If a
spoken command is not available,
the system will inform you of its
status. For optimum functionality,
keep interior noise levels to a
minimum; otherwise, the system
may not understand the command.
3. To end voice recognition, remain
silent. After approximately five
seconds of silence, the system
automatically cancels Voice
Recognition.
See your Navigation manual for
additional operating instructions.
(Talk) button on the