Advertisement
Step 14: Attach Panel A to the unit as shown in Fig. N with 6 KD screws.
Step 15: Attach 2 panels [Q] as shown in Fig O.
Step 16: Tighten all KD screws.
FIREPLACE INSERT INSTALLATION:
The fireplace insert can be installed after the mantel has been fully assembled.
WARNING: Make sure the fireplace insert controls are in the OFF position and the
unit is NOT plugged in.
Step 1: Carefully place the insert in the unit opening. The front of insert should be
flush with the front of the mantel. Carefully lift the insert into the mantel until
the top stopper is against the mantel.
Step 2: Attach 3 short KD screws (U) at the top of insert and attach the L-mounting
bracket to base panel with 2 short KD screws. See Fig P.
Fig. N
back
FrONt
Fig. O
Step 3: Move assembled unit to desired location. Unit should not be positioned in area
exposed to direct sunlight.
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach, you
may use an extension cord rated for a minimum of 1875 WATTS. Once the fireplace
insert has been properly connected to a grounded electrical outlet, it is ready to
operate.
OPERATION BY THE CONTROL PANEL
The controls are located behind the grill below the front glass and can be accessed by
pulling the grill from the top, forward and down.
WARNING: DO NOT TOUCH. HOT SURFACE AT CENTER OF GRILL. HOLD LEFT OR
RIGHT SIDE OF THE GRILL WHEN PULLING OUT.
O/I: Press this button for main power and flame effect. The indicator light will turn on.
See below for other control switches.
1250W: For heat function - Press this switch while the O/I switch is in the ON position.
The indicator light will turn ON.
5
Fig. P
back
Advertisement
