Advertisement
ASSEMBLY INSTRUCTIONS
parts list:
Fireplace insert .................................................................................................................... 1
A) Top panel .........................................................................................................................1
B) Base panel .......................................................................................................................1
C) Middle panel ...................................................................................................................1
D) Left outer side panel ......................................................................................................1
E) Right outer side panel ...................................................................................................1
F) Left inner side panel ......................................................................................................1
G) Right inner side panel ....................................................................................................1
H) Front middle panel.........................................................................................................1
I) Base support ...................................................................................................................1
J) Lower back panel ...........................................................................................................2
K) Upper back panel ...........................................................................................................1
L) Left upper side panel .....................................................................................................1
M) Right upper side panel ..................................................................................................1
Q) Shelves .............................................................................................................................2
S) Shelf support pins ..........................................................................................................8
U) Short KD screws .............................................................................................................5
V) "L" Mounting brackets ................................................................................................. 2
W) KD screws ....................................................................................................................114
X) Plastic connectors....................................................................................................... 38
Y) SELF REPAIR SET
Touch-up repair paint (bottle) ......................................................................................1
L-shape bracket ..............................................................................................................2
Screws for L bracket ......................................................................................................8
Plastic connectors...........................................................................................................1
KD screws ........................................................................................................................3
KD nuts ............................................................................................................................3
TOOL REQUIRED: PHILLIPS HEAD SCREWDRIVER
MANTEL ASSEMBLY:
CAUTION: Place a piece of cardboard or protective sheet on the floor in order to
avoid scratching the decorative surface of your mantel during assembly.
Please DO NOT fully tighten the KD screws until all panels are assembled.
NOTE: Each plastic connector is pre-assembled (pre-drilled) on the specific panels
with 2 screws. If the KD screw(s) do not fit during assembly, loosen the 2 (pre-drilled)
screws to adjust the plastic connector until the KD screws are able to be installed.
Tighten all KD screws once all panels are assembled.
Step 1: Attach 6 plastic connectors to panel B and I with 12 KD screws. (2 screws for
each connector). See Fig. A.
2
Fig. A
Advertisement
