Advertisement
Step 2: Attach Base Support panel [D] to the bottom of Base [B] with 2 KD screws.
Attach panel E, F, G and H on the top of Base [B] with 8 KD screws. See Fig. B.
Step 3: Attach Back panel [C] to Base [B] with 3 KD screws as shown in Fig. C.
fig. A
fig. B
Step 4: Attach Top panel [A] to the unit as shown in Fig. D with 11 KD screws.
Step 5: Tighten all screws.
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach,
you may use an extension cord rated for a minimum of 1875 WATTS. Once the
fireplace insert has been properly connected to a grounded electrical outlet, it is ready
to operate.
OPERATION BY THE CONTROL PANEL
The controls are located behind the grill, below the front glass and can be accessed by
pulling the grill from the top, forward and down.
3
fig. C
fig. D
Advertisement
