●
After you set the shutter speed or aperture value, the exposure
level may change if you adjust the zoom or recompose the shot.
●
Screen brightness may change depending on your specified
shutter speed or aperture value. However, screen brightness
remains the same when the flash is up and the mode is set to [ ].
●
To have the setting you did not configure in step 2 (whether
shutter speed or aperture value) automatically adjusted to obtain
standard exposure, hold the shutter button halfway and press the
[
] button. Note that standard exposure may not be possible with
some settings.
●
With shutter speeds of 1.3 seconds or slower, ISO speed is [
and cannot be changed.
●
[
]: Manual
●
Calculation of standard exposure is based on the specified
metering method ( = 59).
Adjusting the Flash Output
Choose from the three flash levels in [
]
You can also set the flash level by accessing MENU ( = 27)
●
and choosing [
●
You can set the flash level in [
MENU ( = 27) and choosing [
[Flash Mode] > [Manual].
●
You can also access the [Flash Settings] MENU screen ( = 27)
when the flash is up by pressing the [ ] button and immediately
pressing the [
Still Images
Movies
] mode.
1
Enter [
] mode.
●
Set the mode dial to [
].
2
Configure the setting.
●
Raise the flash, press the [ ] button and
immediately turn the [
] dial to choose
the flash level, and then press the [ ]
button.
●
Once the setting is complete, [ ] is
displayed.
] tab > [Flash Settings] > [Flash Output].
] or [
] mode by accessing
] tab > [Flash Settings] >
] button.
Before Use
Basic Guide
Advanced Guide
1
Camera Basics
2
Auto Mode /
Hybrid Auto Mode
3
Other Shooting Modes
4
P Mode
5
Tv, Av, and M Mode
6
Playback Mode
7
Setting Menu
8
Accessories
9
Appendix
Index
73