System Connections; Connection To A Personal Computer - JVC 0503-FO-ID-VP Instructions Manual

SYSTEM CONNECTIONS

Connection To A Personal Computer

[A] Using USB cable
To USB
[B] Using i.LINK cable
To i.LINK IN/OUT
[A] Using USB cable
It is possible to do the following things:
Transfer still images stored on a memory card to a
PC.
Use this camcorder as a WebCam. (
[B] Using i.LINK cable
It is also possible to transfer still/moving images to a
PC with an i.LINK connector by using the provided
software, software equipped with the PC or
commercially available software.
NOTES:
Refer to "SOFTWARE INSTALLATION AND USB
CONNECTION GUIDE" for the installation of the
bundled software and drivers.
The software operation manual is provided as PDF
file on the CD-ROM.
It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the
battery pack. ( pg. 13)
Never connect the USB cable and the i.LINK
cable simultaneously to the camcorder. Connect
only the cable you wish to use to the camcorder.
USB cable (provided)
OR
i.LINK cable
(optional)
When using an i.LINK cable, be sure to use the
optional JVC VC-VDV206U or VC-VDV204U
i.LINK cable depending on the type of i.LINK
connector (4 or 6 pins) on the PC.
If the PC connected to the camcorder via the USB
pg. 68)
cable is not powered, the camcorder does not
enter the USB mode.
The date/time information cannot be captured into
the PC.
Refer to the instruction manuals of the PC and
Software.
The still images can also be transferred to a PC
with an i.LINK connector-equipped capture board.
The system may not work properly depending on
the PC or capture board you are using.
"USB MODE" and/or "ACCESSING FILES"
appears on the LCD monitor while the PC is
accessing data in the camcorder or the camcorder
is transferring a file to the PC.
NEVER disconnect the USB cable while
"ACCESSING FILES" is displayed on the LCD
monitor since this can result in product damage.
To USB connector
To i.LINK
connector
PC with i.LINK
connector
67
EN
PC