Product Warnings - Silicon Graphics 1400 Quick Start Manual

Product Warnings

Caution: The power supplies in this product contain no user-serviceable parts. Refer
servicing only to qualified personnel. Do not attempt to modify or use a supplied AC
power cord if it is not the exact type required. The server has a separate AC power cord
for each supply. The DC push-button on/off switch on the system does not turn off
system AC power. To remove AC power from the system, you must unplug each AC
power cord from the wall outlet or power supply.
Whenever you remove the chassis covers to access the inside of the system, follow these
steps:
1. Turn off all peripheral devices connected to the system.
2. Turn off the system by using the push-button on/off power switch on the system.
3. Unplug all AC power cords from the system or from wall outlets.
4. Label and disconnect all cables connected to I/O connectors or ports on the back of
the system.
5. Provide some electrostatic discharge (ESD) protection by wearing an antistatic wrist
strap attached to chassis ground of the system—any unpainted metal surface—
when handling components.
6. Do not operate the system with the chassis covers removed.
After you have completed the six SAFETY steps above, you can remove the system
covers. To do this:
1. Unlock and remove the padlock from the back of the system if a padlock has been
installed.
2. Remove and save all screws from the covers.
3. Remove the covers.
Product Warnings
17