Scooter Controller Internal Diagnostics - TGA Eclipse Operating Instructions And Owner's Handbook

Table 2: Scooter Controller Internal diagnostics
The diagnostic flash codes for your scooter are designed to help you perform basic troubleshooting quickly and
easily. A diagnostic flash code flashes from the diagnostic light in the event one of the conditions listed below
develops.
Number of
Flashes
The battery needs charging or there is a bad
1
connection to the battery.
2 There is a bad connection to the motor.
The motor has a short circuit to a battery
3
connection.
4 Not available
5 Not available
6 The controller is being inhibited from driving.
7 A speed control lever fault is indicated.
8 A controller fault is indicated.
9 The parking brake has a bad connection.
Excessive voltage has been applied to the
10
controller.
If you are in any doubt about carrying out any of the previous suggestions please contact your dealer or
TGA.
Possible
18
Solution
Check the connections to the battery. If the
connections are good, try charging the battery.
Check all connections between the motor and the
controller.
Please contact your Authorized Service Center.
Check the battery charger connector.
Remove the battery charger from the scooter.
Make sure that the speed control lever is in the
rest position before switching on the scooter.
Make sure that all connections are secure.
Check the parking brake and motor connections.
Make sure the controller connections are secure.
Check the battery connections. This is usually
caused by a poor battery connection.