Addressing; Program Starting Address; Program Starting Address Without Calibrating Luminaire - Philips Vari-Lite VL3015 Spot Luminaire User Manual

Addressing

Program Starting Address

The address setting for DMX console controlled systems is entered using the Menu Display (refer to
"Menu Operation" on page
Note: Refer to your console operating instructions for specific information regarding its addressing
requirements.
Program a DMX starting address:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Address appears. Press [Enter].
Step 3. Press [Up] / [Down] arrows to enter starting address.
Step 4. Press [Enter] to set.
Program Starting Address Without Calibrating
Luminaire
It is possible to bypass the calibration sequence and go directly to the Menu Display programming in
order to pre-program an address setting.

Program starting address without calibrating luminaire:

• While powering up luminaire, press and hold [Menu]. Program address as in
Address
• Press and hold [Menu] until display changes from "Starting" to the DMX address.
Note: The luminaire will require a reset to restore control.
02.96 79.000 2 A
64). The luminaire retains the DMX address even if power is removed.
above.
2 7 Au gu st 2 013
I : A
NSTALLATION DDRESSING
Program Starting
2
19