Setting The Dvd Player - JVC UX-A10DVD Instructions Manual

NOW you are ready to plug in the unit and any other
connected equipment.
ANTENNA
AV
COMPU
VIDEO OUT
LINK
VIDEO
VIDEO OUT
SELECT
S-VIDEO
PAL NTSC
SPEAKERS
AC power cord
When you connect the AC power cord into a wall outlet,
the unit automatically starts the display demonstration
(Automatic display demonstration).
• Each time you press and hold COLOR/DEMO (or
COLOR on the remote control) for more than 2 seconds,
the Automatic display demonstration turns on ("DEMO
ON" appears in the main display) and off ("DEMO OFF"
appears in the main display).
To stop and cancel the display demonstration manually,
press COLOR/DEMO (or COLOR on the remote control)
during display demonstration while the unit is in standby
mode.
• Pressing DIMMER (see page 22) or DISP/CHARA (see
page 17) also cancels the display demonstration.
• "0:00" flashes in the main display until you set the
built-in clock. After setting the clock, the clock time will
appear in the main display while the unit is turned off.
To set the built-in clock, see "Setting the Clock" on page
17.
To start the display demonstration manually, press
COLOR/DEMO (or COLOR on the remote control) while
the unit is in standby mode.
• Each time you press the button, the display demonstration
alternates between on and off.
13
AUDIO
OPTICAL
PCM
DIGITAL
IN
DVD OPTICAL
PCM/
DIGITAL STREAM
OUT
AUX
RIGHT LEFT
LEFT
RIGHT
SPEAKER IMPEDANCE
6~16
To a wall
outlet

Setting the DVD Player

You need to set the following, using the setting menu
shown on the TV, before starting playback.
• You can select the language used in the setting menu.
• If an Audio CD or MP3 disc is loaded, you cannot show the
setting menu. Before starting the setting, remove the disc.
• For further information about the setting menu, see pages
83 to 87.
Step 1 :
Selecting the On-screen language for the
setting menu
Step 2 :
Selecting the monitor type according to
your TV
If audio equipment is connected to the DVD OPTICAL
DIGITAL OUT terminal:
Step 3 :
Selecting the output signal type
If audio equipment is NOT connected to the DVD
OPTICAL DIGITAL OUT terminal:
Setting is finished.
Go to the next page to start the setting.
If no operation is done for about five minutes while
the setting menu appears on the TV
The screen saver screen (see page 28) automatically appears on the
TV instead of the setting menu to prevent the TV screen from
being damaged.
To show the setting menu again, press CHOICE while holding
down SHIFT.