Operating The Tv And Dvd Player; Operating The Tv - JVC TH-L1 Instructions Manual

Operating the TV and DVD player

You can use the remote control to operate not only this unit but also JVC and other manufacturers' TV and DVD
player.
• Refer also to the manuals supplied for the TV and DVD player.
• To operate the equipment, aim the remote control directly at the remote sensor on the target equipment.
The buttons described below are used on pages 14 to
15.
Number
buttons
NOTE
• Manufacturers' codes are subject to change without notice.

Operating the TV

7 To set the manufacturer's code
1
Press and hold
Press and hold the button until step 3 is finished.
2
Press ENTER.
14
TV.
3
Press number buttons (1 - 9, 0) to
enter the manufacturer's code (2
digits).
Examples:
For an AKAI TV: Press 0, then 2.
For a FISHER TV: Press 1, then 7.
* 01 is the initial setting.
JVC 01*
AKAI 02, 17
DAEWOO 08, 09, 29
FISHER 17
HITACHI 24, 26
IRRADIO 17
MAGNAVOX 29
MARANTZ 30
MITSUBISHI 30
PANASONIC 39, 41
4
Release TV.
If there is more than one code listed for corresponding
brand, try each one until you enter the correct one.
7 To operate a TV
You can perform the following operations on the TV.
TV
TV/VIDEO
1 - 9, 0, or +100 while
pressing SHIFT
RETURN while pressing
SHIFT
TV CH +/– while pressing
SHIFT
TV VOLUME +/– while
pressing SHIFT
NOTE
• The operating buttons may differ depending on
manufacturers.
PHILIPS 29
PIONEER 42
02, 20, 46,
RCA
47, 48, 49
29, 51, 52,
SAMSUNG 71, 72, 73,
74
SANYO 17
SCHNEIDER 17
SHARP 54
SONY 55
TOSHIBA 53
ZENITH 69, 70
Turn on or off the TV.
Set the input mode (either
TV or VIDEO).
Selects the channels.
Alternates between the
previously selected channel
and the current channel.
Change the channels.
Adjust the volume.