G23, G26, WSM
7. CHECK AND MAINTENANCE
CAUTION
• Be sure to check and service the machine on a level surface with the engine shut off and the parking brake
"ON" and implement lowered to the ground.
[1] DAILY CHECK
To prevent trouble from occurring, it is important to know the condition of the machine. Check it before starting.
CAUTION
To avoid personal injury :
• Be sure to check and service the machine on a level surface with the engine shut off, the ley removed and
the parking brake securely set.
(1) Walking Around the Machine
1. Tyre pressure, wear and damage.
2. Oil and water leak.
3. Engine oil level.
4. Transmission fluid level.
5. Coolant level in the recovery tank.
6. Damage of machine body, tightness of all bolts and nuts.
7. Radiator screen.
8. Panel screen.
9. Brake free travel.
10. Fuel level.
11. Check air cleaner.
Checking Engine Oil Level
CAUTION
To avoid personal injury :
• Be sure to stop the engine before checking the oil level.
1. Park the machine on a flat surface.
2. Check engine oil before starting the engine or 5 minutes or more
after the engine has stopped.
3. To check the oil level, draw out the dipstick, wipe it clean,
replace it, and draw it out again. Check to see that the oil level
lines between the two notches.
If the level is too low, add new oil to the prescribed level at the
oil inlet. (Refer to "LUBRICANTS, FUEL AND COOLANT" in this
section.)
IMPORTANT
• When using an oil of different maker or viscosity from the
previous one, remove all of the old oil and oil filter.
Never mix two different types of oil.
• If oil level is low, do not run the engine.
(1) Oil Inlet
(2) Dipstick
G-16
GENERAL
9Y1210294GEG0005US0
9Y1210294GEG0006US0
9Y1210294GEG0007US0
A : Oil level is acceptable within this
range.
9Y1210294GEG0008US0
KiSC issued 08, 2009 A
(EU)