Check And Maintenance; Check Points Of Each Use Or Daily; Checking Fuel Level; Checking Engine Oil Level - Kubota W5019-P Manual

S.G GENERAL
W5019W5021 WSM.10481
[9] CHECK AND MAINTENANCE
(1) Check Points of Each Use or
Daily
(a
(b
0617F017
Checking Fuel Level
1. Place the machine on a flat surface (level the
engine).
2. To check the fuel level, remove the fuel tank cap
(1).
3, Check to see that there is sufficient fuel.
4. If necessary. supply the specified fuel until the
proper level is reached.
A
CAUTION
• Before refueling, stop the engine and wait until it
cools down.
• Wipe up any spiltfuel immediately.
• IMPORTANT
• Use the specified fuel.
Refer to "LUBRICANTS AND FUEL", (See page S·3)
(1) Tank Cap
Checking Engine Oil level
1. Place the machi ne on a flat surface (level the
engine).
2. Check the oil level before starting the engine or
wait at least 5 minutes after stopping the engine.
3. Unscrew the oil level dipstick
(1),
wipe it clean,
then screw it in again well.
4. Remove the gauge again and check that the oil
level is between the upper (a) and lower (b) Iim'lts.
5. If the level is too low, supply fresh oil until the
specified level is reached .
• IMPORTANT
• Use the specified engine oil.
Refer to "LUBRICANTS AND FUEL". (See page S·3)
• When using new oil of a different maker or
viscosity from the previous one, drain all used oil.
Never mix two different types of oil.
(1) Oil Level DipstIck
(a)
Upper Limit
(b)
Lower limit
5-29