Remote Control - Chamberlain HD520EV User Manual

Operation
Multi-Function Control Panel (continued)
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from remote controls
while still allowing activation from the door control and keyless entry. This feature is useful for added
peace of mind when the home is empty (i.e. vacation).
Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash as long
l
as the lock feature is activated and your handheld remote control will not operate your door at
this time.
Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED will stop
l
flashing and normal operation will resume.
PROGRAM
Any compatible remote controls, wireless keyless entry, or MyQ
garage door opener by pressing the Learn button.
Push Bar
®
accessories can be programmed to the
Command LED
LEARN Button
LOCK Button
LIGHT Button

Remote Control

Your remote control has been programmed at the factory to operate with your garage door opener.
Older Chamberlain remote controls are NOT compatible, see page 39 for compatible accessories.
Programming can be done through the door control or the learn button the garage door opener. To
program additional accessories refer to the instructions provided with the accessory or visit
www.chamberlain.com. If your vehicle is equipped with a Homelink
adapter depending on the make, model, and year of your vehicle. Visit www.homelink.com for additional
information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE MULTI-FUNCTION CONTROL PANEL
1. Press the LEARN button on the door control to enter Programming Mode.
2. Press the LEARN button again, the LED will flash once.
3. Remote Control:
Press the button on the remote control that you wish to operate your garage door. Keyless
Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry keypad.
Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has been
programmed. Repeat the steps for programming additional remote controls or keyless entry devices.
1
The command LED
will flash once.
3
34
®
, you may require an external
2
The command LED will
flash once again.
OR
? ? ? ?
PIN