Makita BTP140 Instruction Manual page 14

1
2
1. Spring
2. Arm
3. Recessed part
1. Carbon brush cap
1
2
1. Hole
2. Carbon brush cap
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
• Screw bits
• Hook
• Plastic carrying case
• Various type of Makita genuine batteries and
chargers
14
Raise the arm part of the spring and then place it in the recessed part of the
006260
housing with a slotted bit screwdriver of slender shaft or the like.
3
Use pliers to remove the carbon brush cap of the carbon brushes. Take out the
006261
worn carbon brushes, insert the new ones and replace the carbon brush cap
in reverse.
1
Make sure that the carbon brush cap have fit into the holes in brush holders
006304
securely.
Reinstall the rear cover and tighten two screws securely.
After replacing brushes, insert the battery cartridge into the tool and break in
brushes by running tool with no load for about 1 minute. Then check the tool
while running and electric brake operation when releasing the switch trigger. If
electric brake is not working well, ask your local Makita service center for
repair.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
• Stopper (for impact driving)
• Bit piece
• Hybrid drill chuck