Setting The Clock And Delay Brew Time - Oster BVSTEJX Series User Manual

SETTING THE CLOCK AND DELAY BREW TIME

To Set the Clock:
1. Plug the power cord into a standard
electrical outlet. The clock will flash on the
control panel to indicate that the time has
not been set yet.
2. Press and hold the HOUR and MINUTE
buttons until you reach the current time.
The AM or PM indicator will light at the
bottom of the display (Figures 1 and 2).
The clock is now set!
NOTE: Pressing any button before setting the
clock will cause the clock to start keeping time
from 6:00 a.m. You must set the clock if you
want to use the Delay Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode, simply
press the SET DELAY button (Figure 3) and,
while the DELAY BREW time is flashing, set the
brew time by pressing the HOUR and MINUTE
buttons. The AM or PM indicator will light at the
bottom of the clock display. (Figure 4)
Within a few seconds the display will change to
the current time.
The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW cycle, see
the "Brewing Coffee Later" section.
To check the programmed time, push the SET
DELAY button. The display will show the time
you have programmed the coffee to brew. If
you press the SET DELAY button again or wait a
few seconds, the display will switch back.
10
Figure 1
Figure 2
Figure 3
Figure 4