Options Available; Maintenance Notes; Figure 5 - Stack Dryer Control Board - Continental Girbau DL2X30CG Series Operator's Manual

The following two features are available in this dryer. Disconnect power from the machine for two minutes before
modifying the machine for either option.
Anti-Wrinkle Option
The dryer is shipped with this feature defeated. As shipped,
when the machine stops at the end of the cycle, the load will sit
motionless in the machine until the user removes the load. The
feature is activated by removing the small jumper indicated in
the picture. When the feature is activated, it comes into opera-
tion at the end of every cycle if the door is not opened within five
minutes after the cycle finishes. At the end of this five minute
period, the machine will turn on and run for 10 seconds to
redistribute the load. This will occur after each 5 minute interval
that goes by without the door ever having been opened for up
to 16 times. The opening of the door any time during this period
will prevent any further occurrences for that particular cycle.
Last Temperature Used Option
There is a jumper on the control for this feature as shown on
the accompanying picture. As shipped, from the factory, with
the jumper in place, this feature is defeated. This means that at
the beginning of each new cycle the temperature will default to
'warm' if another temperature isn't selected by the customer.
If the jumper is removed from the control, the operation is
changed, so that when starting a new cycle, the temperature
remains at the last temperature selection used in the previous
cycle. This would mean if the previous customer had used a
'hot' selection and the next customer didn't select anything
different they also would receve a 'hot' cycle.
AVAILABLE OPTIONS

MAINTENANCE NOTES

FIGURE 5 - Stack Dryer Control Board - Options
11