Figure 4 - Rear View Of Controller - Continental Girbau DL2X30CG Series Operator's Manual

The controller is put into the programming mode by opening both dryer doors and actuation of a switch on the
controller circuit board and remains in this mode until one of these actions occur:
1. The switch is actuated again.
2. The seventeenth step is completed and the step switch is pushed following the seventeenth step.
3. Programming is stopped for about one minute.
4. The dryer doors are closed.
Four of the membrane switches on the front of the controller become programming switches and both displays
become programming aids.
1. The lower hot switch will advance the controller through the seventeen steps which can be observed or altered.
2. The upper start switch will increase values, the lower start switch will decrease values.
3. The lower perm press switch will restore the value for the program step being displayed to the original value
before it was altered. Also this will return the registers for hours and money to zero if pressed in the appropriate
programming step. (Steps 00 through 03.)
TO CHANGE PROGRAMMED VALUES OR ZERO REGISTERS
1. Open both the upper and lower loading doors.
2. Unlock the control tray, carefully slide the control tray assembly forward about three inches. Press the program
switch. (See fig. 4 "Rear View of Controller") Reinstall and lock the controller.
The controller is now in the program mode at the "00" step, displaying the hours run by the lower drum. (Refer
to the table defining the steps.)
This value displayed can be reset to "0" or observed and left as is. Pressing the lower hot switch will advance
the controller through the fifteen remaining steps allowing observation or alteration.
Note that on any program change or reset it is necessary to advance to the next step by pressing the lower hot
switch to enter the revision. Otherwise the value will remain as it was before the alteration.
SL9-0229
10
FIGURE 4 - Top View Of Controller.