Step 9. Restarting Your System; Step 10. Bcr: Labeling Of Cartridges - Tandberg Data StorageLoader Quick Installation Manual

Hide thumbs Also See for StorageLoader:

Table of Contents

Tandberg Data

StorageLoader

Step 9. Restarting Your System

It is recommended that all external SCSI devices, including the StorageLoader are

powered on before the computer system is re-started. After restarting your system,

including the StorageLoader, the StorageLoader will run a power-on Selftest (like in

step 5 above). When the display reports that the StorageLoader is in the "Idle" state

and the green LED is on, the StorageLoader is ready for further configuration and

operation.

Note: The tape drive needs up to 40 seconds from power on until it's active on the

SCSI bus. It is recommended to turn on the power at least 40 seconds before the

computer system is started.

If your loader is equipped with a bar code reader and you want to use this

functionality, you need to attach bar code labels to the cartridges.

Note: You need to use StorageLoader specific bar code labels to ensure reliable

functionality of the bar code reader. The bar code labels for LTO and DLT

cartridges differ.

Cartridge labels must be oriented on the cartridges as shown in the figures below for

LTO cartridges and DLT cartridges respectively.

Figure 12. Positioning of bar code label for LTO cartridges.

StorageLoader Quick Installation Guide

Table of Contents

Do you have a question about the StorageLoader and is the answer not in the manual?