Care And Cleaning - FoodSaver V4880 series User Manual & Recipe Book

Care and Cleaning

To Clean Appliance:
10
Press Power Button and remove Power Cord
from electrical outlet. Do not immerse in liquid.
Slide out Drip Tray Drawer (P). Remove Drip Tray
for cleaning by pulling up on the two side tabs.
Check Lower Gasket (O) around Drip Tray (P) to
make sure it is free from food materials.
Do not attempt to remove gaskets.
Antibacterial Drip Tray:
Empty Drip Tray after each use. Wash in warm soapy
water or place in top rack of dishwasher. The Adjustable
Food Sensors in the Drip Tray (P) will not function correctly
if liquid is allowed to remain in Drip Tray.
This appliance has a Tray Full indicator
liquid fills the Drip Tray, the unit will turn off and the
Tray Full Indicator light will activate. To resume normal
operation, Slide out Drip Tray Drawer. Remove Drip Tray
for cleaning by pulling up on the two side tabs. When
replacing drip tray, set the right end of the drip tray
into place, then firmly snap both sides down. Appliance
can be used without Drip Tray, however the Adjustable
8 will not function without the Drip Tray.
Food Sensor setting
Retractable Handheld Sealer Reservoir:
Empty Reservoir after each use. Wash in warm soapy water. Air dry
before replacing.
IMPORTANT:
To remove Reservoir from Retractable Handheld Sealer: While holding
top portion by hose pull clear Reservoir down and off.
4
. When excess
www.foodsaver.ca 1-877-804-5383
Slide out drawer to
Push In
access Drip Tray
Tabs
Remove All Food
Around Gaskets
DO NOT
REMOVE
GASKETS
Push In
Tabs
14