Mercedes-Benz E-Class Operator's Manual page 314

Stowage areas
312
To install: insert two brackets A into the
X
left or right loading rail (
Press release button : of the luggage
X
holder and pull the strap out slightly.
Insert luggage holder ; into brackets A
X
and, while doing so, press release button
= and push the luggage holder downwards
until it engages.
Press release button : of the luggage
X
holder and pull the strap out in the direction
of the arrow.
Place the load between the strap and the
X
cargo compartment side wall.
Using one hand, press locking button : of
X
the luggage holder.
With your other hand, let the strap go slowly
X
until the load is secured.
Make sure that locking button ? on
X
brackets A is pressed.
This keeps brackets A in place on the
loading rail.
To remove: press release button = on
X
respective bracket A and remove luggage
holder ; by pulling upwards and out.
Telescopic rod
The telescopic rod can be used to secure the
load against the rear seats to prevent it from
moving around.
X
page 311).
Y
X
X
X
! Unhook the handle before again before
The TIREFIT kit, the vehicle tool kit, etc. are
located in the stowage compartment.
X
To install: insert one bracket ; into both
the left and the right loading rails and slide
it to the desired position (
Insert telescopic rod : into brackets ;
and, while doing so, press release
button ? and push the rod downwards
until it engages.
Make sure that locking button = on
brackets ; is pressed.
This keeps brackets ; in place on the
loading rail.
To remove: press release button ? on
respective bracket ; and remove
telescopic rod : by pulling it upwards and
out.
Stowage well under the trunk floor
(Sedan)
closing the trunk lid and clip it in securely
to prevent the handle flap from protruding.
Otherwise, you could damage the handle.
To open: pull handle : up.
page 311).
Y