Pride Mobility Jazzy Select gt Owner's Manual page 33

V I I . C A R E A N D M A I N T E N A N C E
MOTOR
KEY
AXLE
DRIVE WHEEL WASHER
Figure 19. Jazzy Select Series Drive Wheel Removal
Follow these easy steps for a quick and safe repair for both pneumatic and solid tires:
1. Turn off the power to the controller.
2. Make sure that the power chair is in drive mode. See figure 8.
3. Raise and support the power base so that the wheel is at least 1 in. (2.5 cm) off of the ground.
4. If you are changing a pneumatic tire, completely deflate it before removing the wheel.
5. Remove the hub cap. See figure 19.
6. Remove the drive wheel nut and washer from the axle. See figure 19.
7. Remove the drive wheel from the axle. Make sure that you keep the key.
8. Remove the nuts that fasten the two rim halves together. See figure 19.
9. Remove the old tube from the pneumatic tire and replace it with a new tube or replace the entire assembly if
it is a solid tire.
10. Reassemble the two rim halves.
11. Slide the wheel back onto the axle. Make sure that the key is in the axle slot.
WARNING! Failure to ensure that the axle key is properly installed into the axle slot when mounting
the wheel can result in electronic brake failure, personal injury, and/or product damage.
12. Reinstall the drive wheel nut and washer onto the axle and tighten. See figure 20.
WARNING! Make sure both the nut and the washer are reinstalled and tightened properly.
13. Reinstall the hub cap.
14. Inflate the pneumatic tire to the psi/bar/kPa air pressure rating indicated on each tire.
15. Remove the power chair from the base support.
Jazzy Select GT
DRIVE
WHEEL
DRIVE WHEEL NUT
HUB CAP
www.pridemobility.com
WHEEL
HUB
RIM
HALF
TIRE
WARNING! Completely deflate the
tire before attempting repair.
Figure 20. Jazzy Select Series Drive Wheel Disassembled
TUBE
NUTS
RIM
HALF
33