Advertisement
In this type of installation sound from CS9100 can be played back via car onboard audio
systems in several ways:
1. Via additional speaker, included in the CS9100 package.
2. Via the car original speaker. Connect the onboard speaker to the NAV2NAV adaptor according to
or the connection diagram. In this case the NAV2NAV adaptor switches the sound from the navigation
system to car onboard audio system.
3. With the aid of FM transmitter integrated into the GVIF – interface. Download full manual from our
website for detailed information on this procedure.
4. By connecting the CS9100 line output to the car's AUX input.
When you connect the GVIF interface to the PARKING ASSIST module, make sure that the guiding
rails on the LX IN connector slide completely inside the socket
appear on the multi-display.
Figure 10
CS9100 Navigation System Image Activation
Once you finish all setup procedures, connect again the negative terminal of the accumulator (if you
disconnected it) and switch on the ignition. The on-board computer and all new equipment will switch on.
Press
AUDIO
button
system image.
© 2011 www.car-solutions.com
(Fig.
15)
twice
to see the CS9100 image. Press
(Fig. 13,
Figure 12
6
Version 4.1 02/02/2011
14). Otherwise image will not
Figure 11
MAP
to see the original navigation
support@сarsolutions.com.ua
Table 2
Advertisement
