Advertisement
Disconnect the negative terminal of the accumulator before installing
Before you connect the device, be sure to activate the appropriate protocol of the NAV2NAV adapter using
the DIP switches
(Fig. 1,
Set the DIP switches
(Fig.
DIP Switch #
Switch Setting
Modify GVIF cable before you connect GVIF – interface to the PARKING ASSIST module. Interchange
the positions of LX IN and LX OUT connectors
plastic connector
(marked with a green circle in Fig.
marking. In this case LX OUT connector will not be used. You can detach it completely.
Dismount the glove box from the dashboard. Carefully disconnect all wires that are attached to the
glove box. Mount the CS9100 navigation system in the glove box
back wall of the glove box to fit the connectors of the CS9100 system and "sink" it deeper in the glove box.
Such installation ensures easy access to the navigation system and memory card, which is necessary for
further updates of the navigation maps. Mount the NAV2NAV adaptor on the back wall of the glove box,
using double-sided duct tape or tapping screws.
© 2011 www.car-solutions.com
the CS9100 to avoid errors in the ECU.
2).
Figure 1
2) on your NAV2NAV adapter according to the following
1
OFF OFF
2
3
4
ON
OFF
ON
(Fig.
3) on the GVIF cable. Retrieve the metal pins from the
3) and interchange their positions observing color
Figure 3
(Fig. 4,
2
Version 4.1 02/02/2011
Figure 2
table
1.
5
6
7
OFF OFF OFF
5). Cut a rectangular hole in the
support@сarsolutions.com.ua
Table 1
8
Advertisement
