5). Cut a rectangular hole in the back wall of the glove box to fit the connectors of the CS9100 system and “sink” it deeper in the glove box. Such installation ensures easy access to the navigation system and memory card, which is necessary for further updates of the navigation maps.
Page 3
8), which can be found under the interior fan. PARKING ASSIST module location is shown in Fig. 6 (can differ in other cars). Connect the CS9100 navigation system to the NAV2NAV adaptor connector (Fig. 1), the GVIF interface, and the PARKING ASSIST module wiring (Fig.
Page 6
Version 4.1 02/02/2011 In this type of installation sound from CS9100 can be played back via car onboard audio systems in several ways: 1. Via additional speaker, included in the CS9100 package. 2. Via the car original speaker. Connect the onboard speaker to the NAV2NAV adaptor according to Table 2 or the connection diagram.
Page 7
Figure 136 Figure 147 On the other hand, you can use CS9100 with the GPS antenna included in its package. Install new GPS antenna in the rear spoiler (Fig.
Page 8
Version 4.1 02/02/2011 When you switch on the CS9100 navigator for the first time, you can perform all setup procedures using the remote control or a USB mouse. If CS9100 does not respond to the remote control synchronize them. Press Return and Home buttons simultaneously and hold for 1s.