Windshield Wipers - Chevrolet Metro 1999 Owner's Manual

Headlamp High/Low Beam Changer
To change the headlamps from low beam to high or high
beam to low, push the turn signal away from you. To
switch back to low beams, pull the lever toward you.
Flash-to-Pass
This feature lets you use your high
signal a driver in front of you that you want to pass.
To use it, pull the turn signal/multifunction lever toward
-
you until the high beam headlamps come on, then
release the lever to turn them off.
When the high beams are
on, this light on the
instrument panel also will
be on. It will go off when
you switch to the
low beams.
-
beam headlamps to

Windshield Wipers

You control the windshield wipers by moving the stalk
with the windshield wiper symbol on it up or down.
For steady wiping at low speed, move the stalk down to
-
LO. For high speed wiping, move the stalk down to HI.
To stop the wipers, move the stalk to OFF.
If your vehicle is equipped with intermittent wipers, you
can use this function by moving the stalk to INT. In light
rain or snow, you might want to use this position rather
than continuous wiping.
yellowblue
2-25