Citizen CT-S4000L User Manual

LINE THERMAL PRINTER
MODEL CT-S4000L/CT-S4000DCL
Refer to CT-S4000/CT-S4000DC User's Manual of standard model when reading this manual.
Contents
1.1 Features
4.6 Error Indications
5.3

Manual Setting of Memory Switch

5.4

Selecting Paper Type

5.5 Adjusting Paper Sensor
5.6 Printing Paper
CITIZEN is a registered trade mark of Citizen Holdings Co., Japan
CITIZEN es una marca registrada de Citizen Holdings Co., Japón
Company names and product names in this manual are trademarks or
registered trademarks of relevant companies.
Copyright c 2007 by
CITIZEN SYSTEMS JAPAN CO., LTD.
1.1 Features
High-speed printing at a maximum of 120 mm/sec
2-dimensional barcode
Label of nonstep 58 to 105 mm wide as well as 112 mm is usable
Paper sensor sensitivity adjustment by variable resistor is adopted.
User's Manual

4.6 Error Indication

The following LED indications are added to CT-S4000L/CT-S4000DCL.
Status POWER LED
Wait for cutting label OFF
Paper detection error OFF
5.3 Manual Setting of Memory Switch
Functions of memory switches SW4-4 and SW4-5 of CT-S4000L/CT-S4000DCL are as
shown below. (The white-on-black characters
Memory Switch Function
SW4-4 Paper Select
SW4-5 Position detect
* The Print Width 660 dots is not available for printing a label paper.
* The memory switches SW2-8 will be ignored for Label.
5.4 Selecting Paper Type
Paper type selection is available by the combination of memory switches SW4-4 and
SW4-5 by the used of "Memory Switch Select Mode". In addtion, the following
procedure is available.
1 Enter Selecting Paper Type mode.
1)Open the printer cover and remove paper. Pressing and holding the FEED button,
turn the printer power ON. The POWER LED starts blinking.
2)Release the FEED button and then close the printer cover. Buzzer sounds and
the paper type currently set is indicated by the LED on the operation panel.
2 Select Paper Type.
Press the FEED button to match the paper type loaded to the LED indications in the
table below. (Refer to the table below.)
POWER LED
Label
Green lit
Thermal paper roll
(OFF)
Black Mark paper
Green lit
ERROR LED Buzzer
are factory setting.)
0 (OFF) 1 (ON)
Thermal Roll BM.P/Lbl.P *
Black Mark Label
ERROR LED
(OFF)
Red lit
Red lit