Explanation Of Lights - DeLonghi ECAM 22.110 User Manual

eXPlAnAtIon oF lIGhts

lIGht
FlAshInG
FlAshInG
FlAshInG
FlAshInG
FlAshInG
PossIBle CAUse
Insufficient water in the tank�
The tank is not correctly in place�
The grounds container (A13) is full�
After cleaning, the grounds container has
not been replaced�
The grinding is too fine and the coffee is
delivered too slowly or not at all�
The "pre-ground coffee" function has been
selected without placing any pre-ground
coffee in the funnel�
The machine must be descaled�
Too much coffee has been used�
FlAshInG
The coffee beans have run out�
The pre-ground coffee funnel is clogged�
FlAshInG
ReMeDy
Fill the tank with water and insert it correctly, pushing it as
far as it will go until it clicks into place�
Insert the tank correctly and press as far as it will go�
Empty the grounds container and drip tray, clean and
replace� Important: when removing the drip tray, the
grounds container MUST be emptied, even if it contains
few grounds� If this is not done, when you make the next
coffees, the grounds container may fill up more than
expected and clog the machine�
Remove the drip tray and insert the grounds container�
Repeat coffee delivery and turn the grinding adjustment
dial (fig. 13) one click clockwise towards " 7" while the
coffee mill is in operation� If after making at least 2 coffees
delivery is still too slow, repeat the correction procedure,
turning the grinding adjustment dial another click until
delivery is correct (see the section: Adjusting the coffee mill
on page 12)� If the problem persists, turn the steam dial to
the I position and deliver water from the cappuccino maker�
Place pre-ground coffee in the funnel or deselect the
"pre-ground" function�
The descaling procedure described in the section
"Descaling" needs to be performed as soon as possible.
Select a milder taste or reduce the quantity of pre-ground
coffee then make the coffee again�
Fill the beans container�
Empty the funnel with the help of a knife�
17