Checking The Coolant Level - Yamaha YZF-R1 1998 Service Manual

ADJUSTING THE EXUP CABLES/

CHECKING THE COOLANT LEVEL

3 - 33
5. Adjust:
• EXUP cable free play
a. Loosen both locknuts 1.
b. Insert a 4-mm long pin through the
notch in the EXUP valve pulley and
into the hole in the EXUP valve cover.
c. Turn both adjusting bolts 2 counter-
clockwise until there is no EXUP cable
free play.
d. Turn both adjusting bolts 1/2 of a turn
clockwise.
e. Tighten both
remove the pin.
6. Install:
• EXUP valve pulley cover
7. Install:
• bottom cowling
• fuel tank
Refer to "COWLINGS" and "FUEL
TANK".
EB303220
CHECKING THE COOLANT LEVEL
1. Stand the motorcycle on a level surface.
NOTE:
• Place the motorcycle on a suitable
stand.
• Make sure that the motorcycle is
upright.
2. Check:
• coolant level
The coolant level should be between
the minimum level mark a and maxi-
mum level mark b.
Below the minimum level mark → Add
the recommended coolant to the
proper level.
CAUTION:
ACHTUNG:
• Adding water instead of coolant lowers
the antifreeze content of the coolant. If
water is used instead of coolant, check
and if necessary, correct the antifreeze
concentration of the coolant.
• Use only distilled water. However,
soft water may be used if distilled
water is not available.
CHK
ADJ
locknuts and then
10 Nm (1.0 m · kg)