Singer 2802 Service Manual page 33

Service Manual
Attention:
Make sure the machine is turned off and remove plug from outlet socket
before disassemblying
Removal:
1. Remove the free arm extension table, bed bottom cover, extension table bottom cover,
arm top cover and right side cover.
2. Loose the two motor adjustment screws (A)
3. Carefully lift the motor and slip the motor belt (D) off the motor pulley (E) and the hand
wheel.
4. Cut off the plastic loop (G)
5. Disconnect wire by pulling the bonding jumper (K) apart.
6. Loosen mounting plate screw (B) 4 or 5 turns only.
7. Remove the screw ( J ).
8. Lift motor and tilt its bottom edge out from the machine until mounting plate ( I ) is clear
of the casting edge.
Replacement:
1. Replacement is the same as removal in reverse order. First pass bonding jumper (K)
through the casting groove. The nut on screw (B) must be properly located in the channel
on the inside of the casting to allow mounting motor
2. Put a new plastic loop to fix wire on the casting.
3. Replace all covers.
Rev. n .
o
Motor and Motor Belt
. .
32
358487-001 Mar./2005