Singer 2802 Service Manual page 17

Service Manual
Removal:
1- Remove face plate, arm top cover and needle.
2- Loosen needle bar driving screw (A).
3- Remove presser foot (D) and presser foot screw (E).
4- Remove light socket mounting screw (H), light socket (G) and light shield (I).
5- Remove three head end mounting screws and washers (C), (F) and (J) .
6- Remove head end assembly (B).
Replacement:
1- Replacement is the same as removal in reverse order.
2- Adjust needle location in the needle plate slot and needle to hook relationship. (See
pages 70-71)
3- Check hook timing (See pages 80-81)and needle bar height (See pages 62-63) and adjust
if necessary.
4- Adjust presser bar alignment and height. (See pages 76-77)
Rev. n .
o
Head End Assembly
16
358487-001 Mar./2005