DAHON Bicycle Owner's Manual page 71

Index Shifting Adjustment
Use the shifter while turning the
crank arm to move the derailleur to
the largest sprocket. Then operate
shifter once to move the derailleur
to the 2nd-gear sprocket. After this
operate the shifter just as far as
the extent of play, and then turn
the crank arm.
Best Setting
The best setting is when the
cable adjustment bolt is tightened
(turned clockwise) until noise oc-
curs without the shifter being oper-
ated, and then loosened (turned
counterclockwise) 360 degrees
from that point.
Operate shifter to change gears,
and check that no noise occurs in
any of the gear positions.
When changing to the
3rd gear sprocket.
Turn the cable adjust-
ment bolt clockwise
to tighten it until the
chain returns to the 2nd
sprocket.
3
If shifting to 2nd is not
3 2 2 3
possible, or shifting to
2nd occurs but noise
of the chain contacting
the largest sprocket is
heard.
Change to 2nd and turn
the screw counterclock-
wise until no noise is
heard.
2 3 2 2 2
2 2 2
2 2
71
2
EN