Table of Contents
Advertisement
CAUTION: CUTTING HAZARD Blade is sharp, handle with care.
Blue
Safety Cap
Angled
Cutting edge
Insert this end
into Blade Holder
1
Carefully remove Blue Safety Cap from
Blade, exposing angled cutting edge.
WARNING: MOVING PARTS Keep fingers, hair and clothing away.
CAUTION:
Always unplug Machine before removing or installing Blade Holder.
CAUTION: CUTTING HAZARD Keep fingers away from exposed blade.
1
Lift open Machine cover to expose
Carriage and Blade Holder Clamp.
Clamp
White Ring
Clamp Screw
4
Tighten Blade Holder by turning the
Clamp Screw clockwise until Blade
Holder is secure.
INSERTING BLADE IN BLADE HOLDER
Non-cutting side
2
Carefully insert non-cutting side of
Blade into hole at bottom of Blade
Holder. Blade is held in place
magnetically.
INSTALLING THE CUTTING BLADE HOLDER
Clamp Screw
2
Loosen Clamp by turning Clamp Screw
counterclockwise approximately 1/4 of
a turn. (Important: Spring on end of
Clamp Screw MUST be kept in place.)
CUTTING BLADE MAINTENANCE
3
Note that blade is exposed but barely
visible when inserted properly.
Depth Selection
Arrow
Top edge of Clamp
3
Place Blade Holder into Clamp, making
sure that Depth Selection Arrow is
facing out.
set up
White Ring
Advertisement
Table of Contents
