Table of Contents
Advertisement
This function must be used with the eclips Print2Cut Creative Software (sold separately) on your home computer and
printed with your home printer.
1
Place printed paper on Cutting Mat
with registration marks on left side of
shape. Load Mat into Machine.
4
Use Blade Positioner Control to move
the laser to the top left registration mark
on the material and press
If more than one shape is printed on material, select shape and options and press Cut.
Follow steps 4 & 5.
Print2Cut and Center Point function cannot be used simultaneously.
Print2Cut is active until turned off in Pop-Up Menu by selecting Print2Cut again.
SPEED: 4
PRESSURE: 2
12"x12"
Cardstock L
Solid
Shadow
H: 7.25"
Setup
2
Select same shape on eclips Machine. To
cut around the printed shape and leave
the interior intact, choose Solid, Shadow
or Outline.
5
Use Blade Positioner Control to move
the laser to the lower left registration
.
mark on the material and press
Press
to cut the shape.
R
P
Setup
Space
R
P
SPEED: 4
PRESSURE: 2
12"x12"
Cardstock L
Solid
Shadow
W: 9.51"
QTY: 1
3
Space
.
ADVANCED
PRINT2CUT
Setup
R
Space
P
Add to Favs
Blade Holder
Center Point
Double Cut
Laser Cut Preview
Pen Holder
Print 2 Cut
Rotate
H: 7.25"
W: 9.51"
QTY: 1
R
Setup
Press
. Press
to highlight and
to select, or press
P
twice
Space
to select Print2Cut. The laser will turn
on next to the Blade Holder in the
Machine.
R
P
Setup
Space
Setup
Space
Setup
27
Space
Advertisement
Table of Contents
