Set Up; Connecting; Setting Your Blade Depth; Handheld Remote Control - Ellison eclips EC-C1200 User Manual

set up


SET UP

CONNECTING

1. Plug Power Cord into Universal Power Supply.
2. Plug Universal Power Supply into back of eclips Machine.
3. Plug USB cable into back of eclips Machine.
4. Plug flat end of the USB cable into Handheld Remote Control.
sETTING yOur blaDE DEpTh
NOTICE
DO NOT adjust blade depth while Machine is operating.
Depth Selection
Arrow
Back of machine
2
1
Printed on a ring around the Blade Holder top are Blade Depth Settings. Ranging from 1 to
6, these numbers can be selected individually by turning the wheel to the number relative
to the material you are using.
As a general rule, thinner materials such as paper and vinyl require a lower number
Blade Depth Setting, while thicker materials such as light chipboard and heavy cardstock
require a higher number Blade Depth Setting. For optimal results, try a test cut and make
necessary adjustments to the Blade Depth Setting before performing the final cut.
lower number = Thinner material.
higher number = Thicker material.
3
4
Back of

Handheld Remote Control