Table of Contents
Advertisement
MAINTENANCE
30
MAINTENANCE
CUTTING BLADE MAINTENANCE
CLEANING THE CUTTING BLADE
CAUTION:
After prolonged use, the Cutting Blade may not cut as it once did and may be in need of cleaning. To help prolong the
life of the Cutting Blade, remove it from Blade Holder and clean with Isopropyl alcohol (rubbing alcohol) poured onto
a clean paper towel. Remove any material fragments collected inside Cutting Blade Holder by using Blade Pick from
optional Tool Kit. Visit Sizzix.com to see complete selection of accessories.
ADJUSTING THE CUTTING BLADE DEPTH
CAUTION: CUTTING HAZARD Blade is sharp, handle with care.
WARNING: CHOKING HAZARD Small parts. Keep away from children.
Printed on a ring around the Blade Holder top are Blade Depth Settings ranging from 1 to 6. These numbers may be
selected individually by turning the wheel to the number relative to the material you are using. Refer to pg. 21 for a
more detailed description of how to adjust for the perfect cut.
REPLACING THE CUTTING BLADE
CAUTION: CUTTING HAZARD Keep fingers away from exposed blade.
Clamp Screw
1
Loosen Blade Holder clamp by turning
Clamp Screw counterclockwise.
Remove Blade Holder.
Always unplug Machine before removing or installing Blade Holder.
2
Push down on Blade Ejection Pin to
reveal Blade. Carefully remove and
discard used blade.
Blade Ejection Pin
Blade
3
Non-cutting side
Carefully insert new Blade into hole at
bottom of Blade Holder. Blade is held in
place magnetically. Replace Blade Holder
as shown on pg. 7.
Advertisement
Table of Contents
