Cisco ASR 9000 Series Configuring Network Settings page 13

Configuring the Satellite Network Virtualization (nV) System on the Cisco ASR 9000 Series Router
6.
7.
8.
9.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2
interface interface-name
Example:
RP/0/RSP0/CPU0:router(config)# interface
TenGigE0/2/1/0
Step 3
description
Example:
RP/0/RSP0/CPU0:router(config-interface)#
description To Sat5 1/46
Step 4
ipv4 point-to-point
Example:
RP/0/RSP0/CPU0:router(config-interface)#
ipv4 point-to-point
Step 5
ipv4 unnumbered loopback0
Example:
RP/0/RSP0/CPU0:router(config-interface)#
interface unnumbered loopback0
Step 6
nv
Example:
RP/0/RSP0/CPU0:router(config)# nv
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Configuration Guide
OL-26061-03
nv
satellite-fabric-link satellite <id>
remote-ports interface-type
end
or
commit
Purpose
Enters global configuration mode.
The supported inter-chassis link interface types are limited by the
connectivity provided on the supported satellites. GigabitEthernet,
TenGigE, and Bundle-Ether interfaces are the only support ICL
types.
Specifies the description of the supported inter-chassis link
interface type.
Configures the IPv4 point to point address.
Configures the IPv4 loopback address on the interface.
Enters the nV configuration submode.
Implementing a Satellite nV System
HC-719