The Menu - TANDBERG MXP Systems Short User Manual

The Menu

When the system is not in use, it is in standby mode. The screens are black. Wake up the
system by picking up or pressing any key on the remote control.
When the system is switched on, you will see the welcome screen. The welcome screen
presents the menu and displays your Main Camera image in the background (Main Camera is
system default). Your dial in numbers and system name are displayed in the upper right
corner. Your ISDN Number and IP Number are the numbers that your contacts need to place
a video call to you.
The menu is the Interface you will use to control the system. The menu contains: Make a Call,
Standby, Phone Book, Move Camera, Presentation, MultiSite Services and Control Panel.
When you are in a call, the buttons 'Add Another Call' and 'End Call' will be available via the
red and green buttons (see pictures below).
The menu outside a call and in a call.
When you are in a call, the menu automatically times out after 15 seconds. Press OK/Menu
on remote control to bring it back. You can hide the menu manually by pressing Cancel (X).
If the system does not respond:
Make sure that the system is switched. Please check the
On/Off switch located at the rear of the Codec (see figure).
Verify that the monitor is switched on. To switch the monitor
on you normally push the power button on the front of the
monitor (depending on monitor type).
TANDBERG Short User manual - 4