Citizen PMU-2200II Service Manual page 16

2. Removeng PNE Sensor
Insert from left／Insert from right
1. Remove M4x6(ST) Screw.
*Attention at reassembly
Put Plate Paper Holder and SA PNE Sensor between
Shaft Paper Holder, and stop it with the screw.
Installed position is different depending on the
specification.
6: 60mm
Insert from top
1. Remove M3x3(ST) Screw.
*Attention at reassembly
Put Plate Paper Holder and SA PNE Sensor
between Shaft Paper Holder, and stop it with
the screw.
*Attention at reassembly
The cable is passed through the hole
*Attention at reassembly
Connect BM Sensor with CN108 of
Borad Main do not make a mistake
because
connectors of this type.
CN108 and CN109
-15-
PMU2200Ⅱ/2300ⅡSERIES Service Manual
Shaft Paper Holder
M4x6(ST)
8: 80mm
are
Paper Holder
PNE Sensor
1: 102mm
M3x3(ST)
CN108