Dodge Ram 2010 Owner's Manual page 148

148 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
NOTE: Some gate operators and garage door openers
may require you to replace Step 3 with procedures noted
in the "Gate Operator/Canadian Programming" section.
4. Press and hold the just-trained HomeLink button. If
the channel has been trained, the EVIC display will now
state "CHANNEL # TRANSMIT".
If the EVIC display still states "CHANNEL # TRAIN-
ING" repeat Step 3.
NOTE: After training a HomeLink
garage door does not operate with HomeLink and the
garage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so, proceed
to the heading "Programming A Rolling Code System."
5. PROGRAMMING A ROLLING CODE SYSTEM
At the garage door opener motor (in the garage), locate
the "Learn" or "Training" button.
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor (it is
NOT the button normally used to open and close the
door).
channel, if the
1 — Garage Door Opener
2 — Training Button