Operating The Machine; Shut Down And Daily Maintenance - Clarke BEXTSPOT 04153A Operator's Manual

ENGLISH ENGLISH
EN EN

Operating the Machine

Observe the following guidelines, while cleaning:
WARNING: Always use defoamer if foaming occurs.
Foam will suspend large particles which
may damage vacuum(s), as well as allow
liquid into the vacuum motor(s).
1. Before proceeding, make certain that the nozzle is functioning
properly.
a. To check, hold the hand tool about one foot above the
surface to be cleaned and open the hand tool valve. A full
spray should be observed form the cleaning nozzle.
b. If the nozzle is not showing a full spray pattern, adjust
nozzle for proper pattern, clean, or replace nozzle.
2. Normally, chemical is applied on the push stroke of the hand
tool when cleaning. Vacuuming is done on the pull stroke.
For heavily soiled carpets the hand tool may be used in a
scrubbing manner, applying chemical in both push and pull
strokes. Always fi nish up an area with a vacuum pull stroke.
3. When cleaning, keep the working opening (hand tool mouth)
fl at on the surface being cleaned. Keep the hand tool moving
when the valve is open.
WARNING: Improper discharge of waste may damage
the environment and be illegal. The United
States Environmental Protection Agency
has established certain regulations regard-
ing discharge of waste water. Also, city and
state regulations regarding the discharge
may be in effect in your area. Understand
and follow the regulations in your area.
Be aware of the environmental hazards of
chemicals that you dispose.
-6- FORM NO. 70781A

Shut Down and Daily Maintenance

Shut Down Procedures
For shut down and daily maintenance, follow these procedures:
1. Turn "OFF" pump and vacuum switch.
2. Unplug power cord from outlet
3. Disconnect hand tool.
4. Open access lid. Pour contents into a fi ve gallon pail or toilet.
NOTE: We recommend removing as much moisture from your
vacuum hose as is possible. This will prevent spillage of solution.
5. Unhook the cleaning tool, solution hose, and vacuum hose.
6. Empty the recovery tank by removing the access lid from the
vacuum tank and pouring the contents into a fi ve gallon pail
or toilet. Dispose of the waste in a proper manner.
7. Remove any debris or sediment which may have accumu-
lated inside the recovery tank.
8. Place the access lid back on the recovery tank.
Daily Maintenance Procedures
If properly maintained, this unit will have a long and trouble-free
life. We recommend that you make these maintenance proce-
dures a part of your daily work schedule.
CAUTION: Unplug power cord before servicing or mak-
ing any repairs.
1. Inspect the power cord daily for any sign of damage. If dam-
aged, replace the cord.
2. Inspect the solution hose daily for any damage. If the hose
shows any signs of damage or impending rupture, replace the
hose.
CAUTION: DO NOT attempt to repair hoses. Repairing
high pressure hoses may result in severe
burns and serious injury.
3. Inspect the vacuum hose daily for any damage, breaks, or
tears. Repair or replace the hose, if necessary.
4. Check spray tips daily. Clean spray tips, if plugged.
5. Monthly or as often as necessary, clean out any debris which
may be in the vacuum tubing and hose.
B S
EXT POT
®
Clarke
TM
Operator's Manual (EN)