Table of Contents
Advertisement
How To Operate The Machine
WARNING: Water solutions or cleaning
materials used with this type of
machine can leave wet areas on the
floor surface. These areas can cause
a dangerous condition for the
operator or other persons. Always
put CAUTION signs near the area you
are cleaning.
WARNING: Machines can ignite flammable
materials and vapors. Do not use
with or near flammables such as
gasoline, grain dust, solvents and
thinners. Only use a cleaning
concentration recommended by the
chemical manufacturer.
WARNING: Clarke Technology recommends a
maximum water temperature of
o
120
F (49
Operating The Machine
NOTE: Put the machine in the lowest traverse speed
setting. Use the machine in an area that has no furniture
or objects until you can do the following:
1. Move the machine in a straight direction, forward and
backward.
2. Stop the machine safely.
3. Turn the machine both left and right and return to a
straight direction.
To move the machine, follow this procedure:
1. Release the parking brake.
2. Turn the key switch to the "ON" position
3. Raise the brush to the highest setting.
4. Raise the squeegee.
5. When either the left or right forward/reverse switches
(figure 21, item A) are pushed in, the machine will go
forward.
6. Control the speed of traverse by using the traverse
speed control knob (figure 21, Item C).
7. To stop, release the forward/reverse switch.
8. To reverse the machine, push in the white reverse
switch (figure 21 item B) and either the right or left
forward/reverse switch (figure 21 item A) at the same
time.
9.
To stop, release the forward/reverse switch.
10. To turn the machine, push the rear of the machine to the
side.
11. When you stop the machine, turn the key switch
"OFF", remove the key and set the parking brake.
CLARKE TECHNOLOGY
Operator's Manual SCRUTBTEC BOOST 70
o
C).
B
A
Figure 21
C
A
- 17 -
Advertisement
Table of Contents
