Associating Pre-Registered Appliances - SonicWALL NSA E7500 Getting Started Manual

Associating Pre-Registered Appliances

To associate two already-registered SonicWALL security
appliances so that they can use HA license synchronization,
perform the following steps:
1. Login to mysonicwall.com.
2. In the left navigation bar, click My Products.
3. On the My Products page, under Registered Products,
scroll down to find the appliance that you want to use as
the parent, or primary, unit. Click the product name or
serial number.
4. On the Service Management - Associated Products page,
scroll down to the Associated Products section.
5. Under Associated Products, click HA Secondary.
6. On the My Product - Associated Products page, in the text
boxes under Associate New Products, type the serial
number and the friendly name of the appliance that you
want to associate as the child/secondary/backup unit.
7. Select the group from the Product Group drop-down list.
The product group setting specifies the mysonicwall users
who can upgrade or modify the appliance.
8. Click Register.
If You Are Following
Scenario...
B - NAT with State Sync Pair
Page 38 Configuring a State Sync Pair in NAT/Route Mode
Proceed to Section:
Additional Deployment
Configuration
- page 41
Configuring L2 Bridge Mode
This section provides instructions to configure the SonicWALL
NSA E7500 appliance in tandem with an existing Internet
gateway device. This section is relevant to users following
deployment scenario C.
This section contains the following sub-sections:
Connection Overview
•
Configuring the Primary Bridge Interface
•
Configuring the Secondary Bridge Interface
•
- page 39
- page 39
- page 39