Removing And Installing Front Panel; Removing And Installing Front Grille; Preparation Before Installation - Daikin R410A Split Series Installation Manual

Preparation before Installation

1.

Removing and installing front panel

• Removal method
Hook fingers on the tabs on the left and right of the main body, and open
until the panel stops. Slide the front panel sideways to disengage the
rotating shaft. Then pull the front panel toward you to remove it.
• Installation method
Align the tabs of the front panel with the grooves, and push all the way in.
Then close slowly. Push the centre of the lower surface of the panel firmly to
engage the tabs.
2.

Removing and installing front grille

• Removal method
1) Remove front panel to remove the air filter.
2) Remove the front grille.
3) In front of the
Lightly pull the front grille toward you with one hand, and push down on the
hooks with the fingers of your other hand.
When there is no work space because the unit is close to ceiling
CAUTION
• Be sure to wear protection gloves.
Place both hands under the centre of the front grille, and while pushing up, pull it toward you.
• Installation method
1) Install the front grille and firmly engage the upper hooks (3 locations).
2) Install 2 screws of the front grille.
3) Install the air filter and then mount the front panel.
■English
mark of the front grille, there are 3 upper hooks.
Push the
rotating shaft
of the front
panel into the
groove.
mark area
Upper hook
(3 locations)
Upper hook
Lightly pull the front
Push
grille toward you with
down.
one hand, and push
down on the hooks with
the fingers of your other
hand. (3 locations)
1) Push up.
2) Pull toward you.
4