Acura TSX 2005 User Manual page 211

Main Menu
Lights
FASTENER
AIR INTAKE COVER
1. Open the hood. To change a bulb
on the driver's side, undo the
three fasteners and remove the air
intake cover.
216
Table of Contents
BULB RUBBER WEATHER SEAL
HOLD-DOWN WIRE
2. Remove the electrical connector
from the bulb by pulling the
connector straight back.
3. Remove the rubber weather seal
by pulling on the tab.
4. Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way and remove the bulb.
5. Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
6. Install the rubber weather seal
over the back of the headlight
CONNECTOR
assembly. Make sure it is right
side up; it is marked with an arrow.