Acura TSX 2005 User Manual page 148

Main Menu
HomeLink Universal Transceiver
Erasing Codes
To erase the codes stored in all three
buttons, press and hold the two
outside buttons until the red light
begins to flash, then release the
buttons.
You should erase all three codes
before selling the vehicle.
Retraining a Button
To train an already programmed
HomeLink button with a new device,
you do not have to erase all the
memory. Train the selected button
over the existing memory code
following the steps under
HomeLink'' .
150
Table of Contents
Customer Assistance
If you have problems with training
the HomeLink Wireless Control
System, or would like information on
home products that can be operated
by HomeLink, call (800) 355-3515.
On the Internet, go to www.
homelink.com.
HomeLink is a registered
trademark of Johnson Controls, Inc.
''Training
As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's
authority to operate the equipment.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference that may cause
undesired operation of the device.